Assembly Manual & Height Chart

STEP #1

CHECK PARTS AS YOU UNPACK AND LAY THEM OUT ON THE FLOOR AS SHOWN

Parts List:

STEP #2

ASSEMBLE BASE

Make sure color dots are facing up on The Back Base Bar.

Start with the Back Base Bar

Make sure the color dots are facing up. Match the color codes and insert the Right & Left Lower Bars to the Back Base Bar (Attach with Bolts with Nuts). Then insert the Right and Left Back Bars to the Back Saddles on The Back Base Bar (Attach with Bolts with Nuts).

Insert Upper and Lower extensions into Lower Unit Bars and Back Base Bar (match color codes) (Upper extensions are longer than the lower extensions).

STEP #3

Assemble the Ring

Lay out all 4 ring pieces. Match colored ends and attach with #12 x ¾" Phillips Head Screws.

(If you have a deluxe model the second ring will have double colors on it.)

STEP #4

Attaching The Ring To The Base

Stand base up using bolts in the pre drilled holes to stand the back bars up.

 Attach the ring to the base by sliding the ring saddles into the base connectors. Use dish soap to make it slide easier. Once they are attached insert bolts top hold in place.

Once ring is attached bolts should be used to adjust ring as shown on Chart.

Here is some supplemental information to help you adjust your new Super Swing Trainer. We know you will be excited by the improvement in your game when you practice regularly as suggested in the instructional video.

**Important** The hole closest to the ring is hole 1 the second hole is hole 2 ....

This is just a guideline so if your swing plane feels to upright or flat move the upper pin up or down 1 hole.

Caution:  After prolonged use the exercise cords may experience fatigue. Like anything else, they do wear out. It would be in your best interest to periodically inspect the straps for excessive wear. Breakage while in use could cause injury. Replacement straps are available. A complete set of straps (2) costs $25.99